TPDIN-SC48-20 - Manageable MPPT Solar Controller with 7 port Gigabit PoE Switch
TPDIN-Monitor-WEB2 - New Remote Monitor and Control Unit
TPDIN-Monitor-WEB - Original Remote Monitor and Control Unit
Please visit our knowledgebase to find out more...
Discovery Tool: The Discovery Tool will find the TPDIN™ on your connected network so you can access it even if you don't know the IP Address.
Download Tycon Discovery Tool
TPDIN-SC48-20 - MPPT solar controller with Gigabit PoE switch and remote monitoring and control
TPDIN-SC48-20 is updated using over the air updates. Download the latest firmware from this website and then access the unit webpage and goto the upgrade page, select the downloaded firmware file and upload to the unit. It's that easy. Please right click and use "Save Link As" to download firmware hex files.
VER 2.5.0 Dec 1 2016 Change Bulk timeout from 5hrs to 12hrs
VER 2.4.8 Sept 1 2016 Original Stable Release
TPDIN-Monitor-WEB2 - The new standard for remote monitoring and control
TPDIN-Monitor-WEB2 is updated using over the air updates. Download the latest firmware from this website and then access the unit webpage and goto the upgrade page, select the downloaded firmware file and upload to the unit. It's that easy. Please right click and use "Save Link As" to download firmware hex files.
SNMP MIB File - For Firmware version 2.1.x or later
Released Firmware versions:
VER 2.1.9 Mar 17 2017 Complete re-write to implement SSL email support
VER 2.07 Dec 1 2016 Reorganized web pages, Change relay cycle priority, Fixed shunt resistor calcs
VER 2.03 Nov 14 2016 Fixed I4 log file bug, added load defaults warning
VER 2.02 Nov 8 2016 Original Stable Release
TPDIN-Monitor-WEB - Our original remote monitoring and control system
Firmware and Webpages are a matched set. Upgrade the firmware first and web pages second:
First download the latest firmware (HEX) and web pages file (BIN) . You may need to use "Save Link As" to download the files.
The firmware is updated using TFTP. The command format is "tftp -i 192.168.1.6 PUT 'Tycon Firmware Filename'.hex".
When the Web Voltmeter is first powered up it will accept a TFTP upload on IP Address 192.168.1.6 within 3 seconds of powerup.
Power up the unit and within 3 seconds, start the TFTP command to upload the firmware to the unit.
To update the webpages to the latest you need to access the unit with a browser and enter the units IP address and "mpfsupload" like <IP ADDRESS>/mpfsupload. This will open a page where you can select the web pages file to upload.
3/19/15 New Web Pages File to display hostname in browser tab Web Pages Bin File
8/20/15 New Web Pages File to fix field too small problem with Safari on MAC Web Pages Bin File
11/9/15 New Web Pages File to add a checkbox to disable switch confirmations Web Pages Bin File