Please follow the instruction as below and reset the password to default.
- Turn off the unit, disconnect any Ethernet cables attached to the module.
- Press and hold S1 switch (on the left of the RJ45) and turn on the unit
- After 6 seconds, release S1 and then the unit should revert back to default settings as below:
IP: 192.168.2.1
Gateway: 192.168.2.1
Username: admin
Password: system
- Follow the manual’s RJ45 remote control port section settings, change the factors as below and then start to use.
TCP control: server mode protect timeout set to 0
UART control: Baudrate set to 9600