Factory Reset Instructions for TP-MS616, TP-MS308, TP-MS316, TP-MS324

  1. Turn off the unit, disconnect any Ethernet cables attached to the module.
  2. Press and hold S1 switch (on the left of the RJ45) and turn on the unit
  3. After 6 seconds, release S1 and then the unit should revert back to default settings as below:

IP: Gateway: Username: admin  Password: system

  1. Follow the manual’s RJ45 remote control port section settings, change the factors below and then start to use.

TCP control: server mode protect timeout set to 0 UART control: Baud rate set to 9600